WATER HERO P-100 (first year annual fee included)

The Water Hero P-100 is a plumbing leak detection and automatic water shutoff system that monitors continuous water flow in a Home mode or Away mode so you can set the length of time water is allowed to flow in each mode separately. This allows you to accommodate greater flow needs based on your typical use while you are home and less for the use of appliances that draw water automatically even while you are away.  This system includes the first year annual service fee subscription in the prices shown.  Service fee renewals for each following year would be due at $59.88 for 3/4″ and 1″ valves, and at $119.88 for 1.5″ and 2″ valves.

The P-100 features a fully interactive online dashboard that provides minute-by-minute water consumption data, temperature and valve status, which you can view and remotely control on your computer, tablet or smartphone. When a leak is detected users receive a text/email alert followed by automatic water shut-off when there is continuous flow for more than the user’s set amount of time. Water Hero also alerts users when it detects high or low temperatures that could indicate a fire or furnace failure.

The P-100 unit consists of three components and access to the Water Hero software system, and comes in Indoor and Outdoor models. Components include:

Controller Hub with Main Board, Wi-Fi chip and state-of-the-art processor
Water Hero smart electronics, brass water meter and union couplings
¾” 1”, 1.5″ or 2″ Motorized stainless steel ball valve
Installation typically takes approximately 1 hour and requires the following high level steps:

Interconnect unit with existing homeowner Wi-Fi network
Drain water after the point of installation
Cut ~12” to 16” section into the pipe where water enters the home
Assemble and solder any necessary fittings, unions, water meter and actuator valve into the pipe
Operational Requirements

Indoor model must be installed indoors but the outdoor model can be installed outdoors above ground with a protective box for the valve and electronics.
Broadband Wi-Fi connection [unless opting for cellular option] Must have AC power outlet available within 5 ½ feet of Control Hub
Main Board with Wi-Fi chip must be located in reach of 2.4 GHz Internet signal
Pipe installation by experienced plumbing contractor
12” to 16” straight pipe space required
Install after Utility Water Meter or well tanks, near where main water supply enters the building via basement, slab or in garage (can be modified based on space/power options)
Horizontal or vertical installation
Water Hero P-100 must be plumbed after (downstream of) fire suppression systems

Contents

Controller Hub with main board, Wi-Fi chip and state-of-the-art processor
Water Hero smart electronics, brass water meter and union couplings
Full port stainless steel motorized ball valve (3/4”, 1”, 1.5″ or 2″) with 5.5′ interconnect cable to hub
5.5’ AC power adapter and wire for hub power plug in to wall outlet
6’ RJ 45 cable